Setting up a trunk port between the two switches will allow one cable to carry both VLANs traffic. Then you don't need the second link unless you want physical redundancy (but you will need STP in that case).
In some environments, the link between the switch and the router might reside in a subnet that has no available IP address. You can use the following solutions to accommodate the IP address requirement: • Create a secondary interface, with a new subnet and IP address on the router or switch, and pull...
A call between two nodes interconnected by a direct link is first offered to the direct route, and if that is blocked it is offered to a currently nominated two-link alternative route between the two nodes. If that route is busy, the call is lost, and a randomly chosen two-link route is assigned to be the new current nominated alternative route.
No. If your unmanaged switches are so simple that they don't do Spanning Tree Protocol (STP), connecting the second cable between them would cause a bridging loop, instantly saturating your network, making your network unusable until you remove the second cable. If they do do STP, then only one of the switch-to-switch links will be used.
DLS1 is connected to another switch, DLS2, via a trunk link. between two switches that share a common VLAN. A switch with a port that is configured as a trunk is needed when connecting to the router.
Jan 16, 2017 · SIP trunks are virtual phone lines that enable users to make and receive phone calls over the internet to anyone in the world with a phone number. SIP trunks utilize a packet switch network, in which voice calls are broken down into digital packets and sent across a network to the final destination. SIP Channels. Each SIP trunk supports SIP ...
Dec 29, 2020 · This can be helpful to you if you have 2 switch and want to use a single cable to link both switch for many Vlan. If you have only 1 switch then your network card need to support 802.11q. You can create multiple vlan in your pc then connect to your switch. That link wil be called trunk.
For the ports connecting the two switches together, we place the ports in trunk mode and specify the native VLAN and allowed VLANs. For the port e1 that connect the two switches to each other would be configured like this. console(config)# interface ethernet 1/e1. console(config-if)# switchport mode general